MIX Manual (split by node): Section: Back: 3.3.2 Obtaining On-line Help Forward: 3.3.4 Assigning and Listing Devices Chapter: FastBack: 3. mixsim – MIX Simulator. Up: 3.3 Terminal Mode and Debugger. FastForward: 4. mixrun Doc: Contents: Table of Contents Index: Concept Index   ?

3.3.3 Quitting the Terminal

QUIT
Q

To exit the terminal, use the QUIT (abbreviated Q), or type an end-of-file character (usually C-d).

An interrupt (C-c) does not exit from mixsim, but rather stops the program being executed (see section Stopping and Continuing), or, if no program is being run, cancels the current input line.

This document was generated by Sergey Poznyakoff on October, 30 2009 using texi2html 1.78.

Verbatim copying and distribution of this entire article is permitted in any medium, provided this notice is preserved.